1. After cleaning the placement location of the box, it should be covered with pearl cotton.
LED display screens are not allowed to stack modules randomly or stack more than 10 pieces. When stacking, place the lamp faces relative to each other and isolate them with pearl cotton.
3. It is recommended to place the LED display box flat with the light facing upwards. If there are too many, special attention should be paid to protection when placing them upright. It is prohibited to place them upright in areas with high vibration.
4. The display box should be handled with care, and when landing, the back side should first land on the ground and then the lamp surface to avoid injury.
During installation or maintenance, all personnel must carry cordless anti-static wristbands.
6. LED display screen installed with anti-static wristband.
When moving the box, it should be raised and not pushed or dragged off the ground to avoid uneven ground and damage to the bottom mold. The box should be balanced when lifted and cannot sway or rotate left or right. Packing and assembly parts should be handled with care and strictly prohibited from being thrown out.
8. If LED display products need to be adjusted, you can use a rubber hammer to hit the metal part of the box, and it is prohibited to hit the module. Squeezing, collision, and other behaviors between molds are not allowed. In case of gaps, abnormal positioning, etc., do not use hard objects such as hammers to strike the box and module. Try again after removing the foreign object.